Menu
ITEM #67223

FORD

KU-BAND VAN - 1.2m DISH, EQUIPPED, 7.2KW GEN


Inquire

2001 FORD E-350 SUPER CARGO KU-BAND VAN - BUILT OUT BY FRONTLINE - UNDER 5,500 ORIGINAL MILES - - NEW TIRES - WELL MAINTAINED - 7.2KW GENERAC GAS GENERATOR

DIGITAL KU BAND SNG RF EQUIPMENT (PRIMARILY SD - WITH AN ENCODER UPGRADE, THE KU SYSTEM WOULD BE HD):

  • Advent 1.2 Meter Advent Newswift Mobile Ku Band Antenna with 2
    Port Broadband Feed, 3 Axis Drive and Controller, and Pol/El
    Cross Axis Waveguide Kit.
  • N6310 Marconi 100 Watt Ku Band TWT Power Amplifier
  • N6143 Marconi TWT A Controller with forward power detector and
    readout
  • U9696-3-L Miteq 70 MHz to Ku Band upconverter, 125 KHz step
    frequency agile tuning, with variable output level control and
    L-Band Monitor for Loop Back Test.
  • TE-3000RF Tiernan Digital Encoder/Modulator
  • TRD 78 Tiernan Integrated Decoder/Receiver
  • 1209HA Norsat Phase Stable +/- 25 kHz Digital LNB, . 9 db NF
  • ESR1255 Drake Analog Ku Band Satellite Receiver
  • 1705A Tektronix Spectrum Monitor w/ l 700FO5 Rack Mount & l
    700FO6 Blank Panel
  • EDH-3W Env. Tech. Environmental Technologies waveguide
    dehydrator
  • WGS Frontline Waveguide antenna/load switch with control panel
  • Frontline RF Waveguide, Cables, Connectors and misc.
    installation hardware.
  • Frontline Installation, wiring, test and documentation of
    Digital RF system.

AUDIO, VIDEO AND TEST EQUIPMENT:

  • Tektronix 1740A Waveform I Vectorscope
  • Tektronix l 700F05 Dual Rack Mount Adapter
  • Tektronix TSG200 NTSC Test Signal Generators
  • Tektronix TVGFI lA Rack Mount
  • Ikegami PM404 Quad 411 B/W Monitors
  • Ikegami TM9-IRM2 Dual 9" Color Monitor Pack
  • Leitch XPR-12V A2-CPB 12 x 1 Routing Switcher w/ Dual Audio
  • Leitch XPR-CABSUP Cable Suppmt Bar
  • ADC HUM-I Humbucker Coils
  • Leitch FR-684 10 Position Video DA Frame and PS
  • Leitch 684PS Redundant Power Supply for FR-684
  • Leitch VDA-683 Video DA's
  • Leitch VEA-684 Equalizing VDA's
  • Leitch FR-884 IO Position Audio DA Frame and PS
  • Leitch 884PS Redundant Power Supply for FR-884
  • Leitch AMD-880 Audio DA's
  • Canare 24-ZU-DVJW 24 x 2 Video Patch Panel
  • ADC BK3 Video Patch Cord
  • ADC BJF-207-4MKII 24 x 2 Audio Patch Bay
  • ADC G3 Audio Patch Cords
  • Crown D-75A Audio Amplifier
  • JBL Control-I Speakers w/ Mounting Brackets
  • Shure FP-42 Stereo Audio Mixers w/ Al6R Rack Mount
  • Dorrough 40-A Loudness Meters with Dual Rack Mount
  • Wohler Technologies AMP2A-2S Audio Monitors
  • Sony SVO-1430 VHS VCR w/ FEC Rack Mount
  • Henry Audio Matchbox
  • Antennacraft Mini-State 5MS750 Off Air Antenna
  • Motorola Cellular Telephone w/ RJ-11 Interface and Antenna
  • Installation, wiring, test and documentation of all audio,
    video, and test equipment. All cables and wires are numbered
    and referenced to customer approved flow diagrams. All audio,
    video and RF cables and construction techniques meet highest
    industry standards.

INTERCOM AND IFB EQUIPMENT

  • Wall Telephones
  • Telephone Patch Panel
  • IFB Monitor Speaker
  • Studio Technologies Model 2 IFB Plus Central Controller
  • Studio Technologies Model 32 Talent Amplifiers
  • Audio Implements IFB Talent Earpiece Kits
  • RTS MCE325 Programmable User Station
  • RTS MCS325 Modular Speaker w/MCPl Rack Mount RTS MCPS 1211
    Panel Mount Microphone
  • RTS PSIS Power Supply w/MCP2 Rack Mount
  • RTS BP325 2-Channel Belt Packs
  • Beyer DT108 Single Muff Headsets w/ RTS Connectors
    Installation, wiring, test and documentation of all intercom
    and IFB equipment. All cables and wires are numbered and
    referenced to customer approved flow diagrams. All audio,
    video and RF cables and construction

GENERATOR:

  • 7.2 KW Generac gasoline generator installed in custom fabricated aluminum compartment.

VAN FEATURES:

  • 6.8 Liter V-10 EFI gas engine
  • GVWR 9,400 lbs.
  • Electronic 4-speed automatic transmission with auxiliary
    transmission oil cooler
  • Heavy duty service package including dual electric horns,
    heavy duty 130 amp alternator and auxiliary fuel port
  • 4 Wheel Anti-Lock brake system
  • 3 .73 Rear axle ratio
  • Power steering and brakes
  • Dual 12 volt batteries (wired in parallel)
  • 35 gallon fuel tank
  • Class I trailer towing package
  • CFC-Free Air Conditioning & Heat
  • Cruise control and tilt steering wheel Power windows and door
    locks
  • Chrome front and full width rear step bumper
  • Captain's chairs with reclining back and folding armrests
    AM/FM Cassette stereo with digital clock
  • 97 DB back-up alarm

STABILIZER SYSTEM:

  • 2 Rear chassis mounted 6,000 lbs (ea.) Hydraulic stabilizer
    jacks

ROOFTOP PLATFORM:

  • Full length aluminum rooftop platform to mount communication
    antennas and access mast top equipment.

ANTENNA PLATFORM:

  • Re-enforced aluminum satellite antenna mounting platform
    located over the roof top A/C unit. Heavy duty aluminum roof
    access ladder installed on rear door.

INTERIOR FINISH:

  • The interior of the van is fully insulated
  • R-11 Retlectex bubble pack insulation in walls and ceiling.
  • Walls 1/4" and ceiling 3/8" paneled with finish grade plywood
    (luan) with 3/4" AC plywood installed on the floor throughout
    the van excluding the driver and passenger area
  • Floor, walls and ceiling are covered with closed loop
    antistatic carpeting (carpet color matches van interior)
  • Rear storage area floor covered with heavy duty rubber
    flooring

COMMS/VO:

  • Communications Audio connector panel installed in the post
    immediately behind the passenger seat, includes XLR and RJ-l
    l connections. Wires terminate in the base of rack #3. May be
    used to create reporter position with mic and telephone or
    computer modem interface

EQUIPMENT:

  • (4) equipment racks with a total of 87 standard
  • RACKS 1.75" rack units for equipment installation
  • (3) racks are installed across the rear axle section of the
    vehicle. Rack #4 is located behind the drivers seat against
    the street side wall. Access to rack 4 is through exterior
    street side door
  • Each rack has two 6-outlet multiple AC strips for power
    distribution
  • Equipment racks are trimmed with varnished white oak to match
    console trim
  • (2) cooling fans (120 VAC) are installed in the oak trim
    board at the bottom of the racks 1-3
  • Rack #4 has side mounted cooling fans
  • (2) vents are located in the oak trim board at the top of the
    racks. Ambient air is constantly circulated through racks to
    keep the equipment cool

INTERIOR LIGHTING:

  • (4) directional DC spotlights installed in the ceiling above
    equipment racks. Each light has on/off switch, and entire
    bank of spotlights is wired with continuous dimmer control.
  • (1) DC fluorescent light fixture in rear maintenance area
  • (1) DC fluorescent light fixture in operations area

ELECTRICAL SYSTEM:

  • Custom power distribution panel, black with white silk
    screened labels.
    Panel includes:
  • AC & DC circuit breakers for all branch circuits
  • Analog voltage, current and frequency meters
  • Generator/External Power select switch
  • Remote generator control switches and digital hour meter
  • 40 amp automatic battery charger/DC converter.
  • (3) Interior duplex AC outlets
  • (3) weatherproof duplex 20 amp GFI AC outlets on exterior of the vehicle (1) streetside, (1)
    curbside and (1) on the roof platform.

EXTERNAL POWER:

  • 120 volt, 50 amp external "shore" power system
  • Marine style chrome plated input connector.
  • 50' power cord with locking connector and weathertight boot.

EXTERIOR LIGHTING:

  • (2) flush mounted DC halogen scene lights on each side
  • (l) rear mounted work light
  • (1) mast mounted DC light for antenna orientation
  • (1) mast mounted amber rotating beacon.
  • High mounted tail lights, brake light and turn signals on rear
    of platform.

AIR/HEAT:

  • 13,500 BTU Duo-Therm roof mounted air conditioner with
    integral 5,000 BTU heat strip.

I/0 PANEL:

  • Custom made aluminum 1/0 panel is machined and labeled with
    connectors installed per customer specifications.

MISC:

  • 5B:C Halotron extinguisher fire extinguisher mounted in
    operations area.
  • Spare parts kit including spare light bulbs, fuses, circuit
    breakers, and misc. hardware all contained in a sn1all tool
    box.